Snowex VBR-400 Manuel d'utilisateur télécharger pdf (Page 3)

Installation Instructions

Model # VBR-400

STEP 1

Remove the Nut from the Inverted-V on the Front, Passenger-

Side Corner.

WEAR EYE PROTECTION.

Installing the Vibrator

STEP 2

Inside the Hopper...

Grind the welds off the Weld-Stud. Once the welds are ground off, the Weld-

Stud can be removed from the Inverted-V.

STEP 3

If desired, prime and re-paint where the powder-coat has been removed by

the grinder.

STEP 4

Set the Vibrator on top of the Inverted-V to use as a template for drilling the

mouting holes in the hopper. Drill the four mounting holes with a 3/8” bit.

1 2 3 4 5 6 7 8 ... 11 12

Pas de commentaire

Snowex VBR-400 Manuel d'utilisateur Page 3