Snowex VBR-400 Manuel d'utilisateur télécharger pdf (Page 5)

Installation Instructions

Model # VBR-400

STEP 4

Drill a 1-1/8” Hole in the Control Box in the location shown.

Drill the hole here.

STEP 5

Insert the VBR-400 Harness [F50846] through the hole drilled in Step 2.

Thread on 1/2” NPT Nut [D6781] and tighten.

STEP 7

Connect the Black Wire (-) of the VBR-400 Harness to the ‘GND -’ Stud.

Re-connect the wires that were removed in Step 3. Tighten the Nut (and

washer) onto the Stud.

STEP 8

Connect the Red Wire (+) of the VBR-400 Harness to the ‘VIBRATE’ Stud.

STEP 9

Refer to the Diagram on the next page to check that all wiring is connected

correctly.

STEP 10

Route the VBR-400 Harness along the frame and to the Vibrator. Use zip-ties

(included in kit) to secure.

STEP 6

Reconnect the Auger Harness to the ‘AUGER +’ and ‘AUGER -.’

STEP 1

Remove the Auger Extension Cover.

STEP 3

Remove all wires from the ‘GND -,’ ‘AUGER +’ and ‘AUGER -’ Studs.

STEP 2

Remove the Clear Cover from the Control Module Box.

Installing the Wiring

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Snowex VBR-400 Manuel d'utilisateur Page 5